This is a common wear item on high mileage 126 chassis. It will start out as a clunking noise when you go over rough ground. When real bad it will be hard to get your car to track right down the road (it will want to wander) and you will experience uneven and rapid tire wear. Note this part has a small ball joint that wears out with age and use. High Quality Dephi brand. Fits all 126 sedans and coupes right front from 1981 to 1991.
Product Details
- Mercedes-Benz 300SD
- Mercedes-Benz 300SDL
- Mercedes-Benz 300SE
- Mercedes-Benz 300SEL
- Mercedes-Benz 350SD
- Mercedes-Benz 350SDL
- Mercedes-Benz 380SE
- Mercedes-Benz 380SEC
- Mercedes-Benz 380SEL
- Mercedes-Benz 420SEL
- Mercedes-Benz 500SEC
- Mercedes-Benz 500SEL
- Mercedes-Benz 560SEC
- Mercedes-Benz 560SEL
Be sure to check out Kent's video on inspecting your front suspension.
PLEASE NOTE: This part does not come with the two rubber bushings that support the sway bar in the upper hole of this control arm. In most cases these rubber bushings will be collapsed or cracked from age. We recommend you also order our two (2) bushing kit for each control arm. See related products below:
Location of upper control arm on car
Related Products:
126 Chassis Left (Drivers side) Front Suspension Upper Control Arm
This is a very common wear item on high mileage 126 chassis. It will start out as a clunking noise when you go over rough ground. When real bad it will be hard to get your car to track right down the road (it will want to wander) and you will experience rapid and uneven tire wear..
All 116 123 126 Front Upper Control Arm Bushings x 2
These bushing go on either side of the upper control arm where it attaches to the stabilizer arm. These should be replaced if worn or installed new upper control arms. SOLD IN A SET OF 4 as required by car. See related products below for the upper control arms that these bushing fit into.