6 Foot Long Multipurpose 12v Test Lead Kit w/ On-Off Switch

Ready to use. VERY High-Quality leads and removable clips, and you won't have to worry about shorts if you use the switch on the power lead! Thin wire probe now included!

 

6 Foot Long Multipurpose 12v Test Lead Kit w/ On-Off Switch
$28.75
SKU:
ELT-6FTTESTLEADKIT

Product Details

KENT DEMONSTRATES HOW IT WORKS

You won't see anything like this anywhere else!  Have you ever connected test leads to a battery only to have the tips short out against some part of the car?  Have you ever used test lead clips that short out when they touch each other? Have you ever had a hard time testing female plug connectors? Watch the video below for the solution. This is an easy kit you can assemble yourself.  You will need a wire stripping tool, a terminal crimping tool, and a heat gun.

Please note: Since filming the video, Kent is now using a higher quality plug and clip on the ends of the wires. These are the very best electric clips that Kent could find. Easy to open and attach very firmly. The on/off switch will give you peace of mind when testing components for operation. 

Big strong clips to connect to the battery

Small, fully insulated clips to connect to pins or fasteners of what you are testing.

All clips are removable exposing high-quality banana plugs that can be inserted into female plugs for testing.

Since the ends of the soft, high-quality wires have banana plugs installed, you can easily attach other probes that have a 4mm hole. We include a super thin, very sharp wire probe to get into tight places or push right through the insulation of a wire for testing.


ASSEMBLY TIPS:

You can locate the switch anywhere along the red wire you want, but consider having it close to the end where you are doing the testing.  Suggestion: Cut the red wire 8 to 12 inches from the end and splice in the switch using the two pink connectors. BEFORE crimping the connectors, slide the shrink tube down the wires 6 inches away from the connectors - crimp the connectors - heat the ends of the connectors to shrink them tight to the wires - then push the shrink tubing over the connectors - then use the heat gun to shrink the black tubing.

 

 

Related Products: