Search | W114 | On Demand Video

Door hinge lubrication has to be one of the most neglected maintenance items on the older models. I think part of the problem stems from the fact owners don't know how to do it or don't know how to acquire the proper grease gun to lubricate those special fittings on the door hinges.

In this short 2:32 minute video Kent will show you how he first tests the sunroof drains for blockage and then how he goes about cleaning out any blockage.

Old cars and brake issues go hand in hand. Especially if the car is not driving very often. Brake problems usually first show up as “dragging” or sticking brakes. If this issue is not dealt with immediately it can lead to serious problem including the car catching on fire. 

Kent will walk you step-by-step through the process of cleaning and prepping the old caliper for the new seals. He will share his recommendations on painting as well as how to retard the rust inside the caliper housing.

On older Mercedes spot rust can be a hidden problem under side moulding trim, under fenders and rocker panels and inside the bottom edges of doors.

Installing new front rotors on older model Mercedes requires that you remove the rotor from the bearing hub and bolt the new rotor back on. Sounds easy right? Sometimes not! The bolts are on very tight and often take a lot of torque to remove. How do you hold the break rotor while doing this?

When replacing the steering lock assembly in your Benz you will need to remove that little black plastic switch on the side of the lock from the old one and put it on the new part. You can not pry it off, squeeze it off or pull it off by hand. 

If both dash lights are not working including the lights in the upper center console the problem is most likely in the dimmer switch located on the back of the instrument cluster. This is also called the potentiometer providing variable resistance in the wiring to the bulbs.

Tired of lugging around heavy batteries or battery boosters to test electrical components in your car? It does not have to be a Mercedes. It does not even have to be a car. Anything that runs off 12 volt DC power can be tested by these small, light weight but very powerful batteries.

Interior water leaks are very common. More so on the older 108, 116, 114, 115. 123, and 126 chassis than on the 201 and 124 chassis. This is largely due to the fact that the older models used rubber seals on the rear glass and on the front windshield (except the 126).

Manual sunroofs can have problems too. Just like their electrically operated counterparts, most often they will fail due to lack of lubrication. The number one failure point is a broken T handle. Number two is failure of the roof to close properly due to damaged felt feet and plastic slides.

When an old Mercedes ( or any other car for that matter ) has sat idle for over a year it can be a challenge to get it safely back on the road again. If it has sat idle for more than 5 years you may find it difficult to even get the engine running. 

In this video Kent shares his technique for removing a padded steering wheel on most 107, 114, 115, 116, 123, 126, and 201 to 1985 chassis. These are the models WITHOUT an airbag.

To many people, automotive electrical systems and testing are a big mystery. It is not as complicated as you might think.

In this 10 minute video class Kent shows you what you should initially look for when checking out an older Mercedes for sale. He routinely does a quick 3 to 5 minute walk around to determine if the car passes his priority three part test. 

Those three areas on inspection are:

In this video Kent shares his secrets on how to make the inside of an old Benz look like new again. Now granted, you must have a reasonably good car to start with.  He is not going to show you how to reupholster, change seats and door panels, etc.

In this xx-minute video, Kent will share some tips and tricks to get new side seals installed in your old Benz. We are sorry we are not able to supply side seals at this time, as the aftermarket ones available are lacking in quality.

In this 32-minute, very detailed video, Kent will show you how you can fix some heavy rust pitting and small rust-out holes in the trunk of your classic Benz. This technique also works on floors and under body panels.

In this short video, Kent will demonstrate how to prep the sunroof if there is rust in the seal area and how to install a new rear seal using the tool, lubricant, and glue provided in his kit. PLEASE NOTE: The sunroof panel has to be removed from the car.

In this 24-minute instructional video, Kent shows you more than just how to change the transmission filter and the pan.

In this 17-minute video instruction, Kent walks you through the steps to install his door liner kit using thick, clear, and high-quality plastic sheets on both front and rear doors. A W123 sedan is shown here, but the principles are similar for other chassis. 

In this 30 minute instructional video Kent will use a 1972 300SEL 4.5 to show you how to remove the master cylinder with minimal spillage, how to install the tank and bench bleed a new master cylinder, and how to reinstall it with minimal brake fluid spillage while protecting your car's paint. 

Also covers 1980 W116 sedans. In this 20-minute instructional video, Kent will walk you through the steps of getting the steel sunroof panel installed properly back into the car's roof. The first step will require cleaning, inspection, and possible replacement of the plastic slides.

In this 36-minute instructional video, Kent will walk you through the process of doing a complete fuel hose replacement and fuel injector service on a 1970 to 1975 Mercedes V8 engine with Bosch EFI electronic fuel injection.