ALERT: Miracle Paint is back in stock! CLICK HERE to order.
This tester does not include extras or instructions. It is intended for use by someone who knows how to hook it up and read pressures on a D-Jetronic fuel injection system. If you need instructions, they are included in our full kit. See the related products below.
The wiring plug covers must be removed with a special tool in order to install these boots. The old covers will break when you try to remove them. We recommend you buy new wiring covers when replacing either my aftermarket custom-made silicone boots or the original rubber boots.
You can use these to remove the wires and just replace the plug cover on your D-Jet V8 engine. Most of the originals are brittle or broken due to heat. As an alternative you can use butt connectors and wire them into your existing harness.
In Kent's 32-minute video on rewiring the plugs on your D-jetronic fuel injectors, he will walk you through the two options on how you can use this kit - then show you how in do it and finally give you some tips on automotive wire splicing using the best tools and supplies.
On most D-jetronic engines, the fuel injector wiring plugs are hard and brittle and the boots are torn or missing altogether. You may say, "If it is working, why fix it? Watch the videos below to understand why this is important and how easy it would be for you to do it yourself.
The original fuel filter has a rigid right-angle fitting, as shown in the pictures below. We do not provide this fitting in our fuel delivery kits as more often than not it can be removed from your old filter and installed in the new filter we provide.
Testing fuel pressure is a simple procedure on the D-Jetronic engines, but it is absolutely essential.
In this 23-minute step-by-step "how-to" video, Kent will show you how to install a new set of fuel injectors in your early D-Jetronic engine. This video is included free with the purchase of our early 3.5 and 4.5 fuel injector sets.
The subjects included are:
If you plan to replace, test, or service your electronic fuel injectors you first must determine which bottom seals you will need. If you have a 1970 or 1973 model, you most likely have the single-bottom seal (unless your engine has been changed).
DO NOT ORDER UNTIL YOU REMOVE ONE INJECTOR IN YOUR ENGINE AND INSPECT THE HOLE. Sometime in 1974, Mercedes changed the way these injectors were sealed into the head to prevent air leaks. A "YELLOWISH" nylon sleeve was added along with two seals on the lower end of the fuel injector.
These plugs will NOT work on your original injectors. They will ONLY work on our new replacements (see below). These plugs are a good alternative to the damaged originals on your D-Jetronic fuel-injected engine only if you are installing our new injectors.
These are the critical seals that go on the D-jetronic fuel injectors. If they leak air, your engine with idle high, start poorly and run lean, which can damage the pistons. We recommend you replace these whenever you remove and replace the injectors.
WARNING: MAKE CERTAIN your current injectors are yellow at the top. A restocking fee will apply if you place an order in error. For the 3.5 engine ONLY. See related products below if you have a 4.5.