Search | W108 W109 | Engine

This is one of Kent's favorite tools around his shop. It is used almost daily. The tool rose out of a need to be able to safely hold fuel inectors while cleaning when with a large high speed wire wheel. No tool like this is availabe so it had to be built in our shop!

New part as shown. See related products below for application. 

Watch the video below to understand what this kit can do. Kent used it on his 6.3, which had sat outside and had not run in 18 years. The 6.3 injection pump is rare, to say the least, and can be very expensive to overhaul. Treat it with great care!

This is seldom replaced. If you engine is taking over 15 minutes to get up to full operating temp then your thermostat is probably worn now. We got you covered with kit. We will get you the extra hardware, supplies and video instructions so you have the confidence to do this job yourself.

This is a great solution to what is sometimes a nagging problem. This heavy duty and flexible and adjustable plastic spacer can be put on the top or bottom radiator to prevent chafing in and area where it might come in contact the the engine or the radiator.

Why do you need to do this?  Valve clearances are supposed to be adjusted on these early V8s every 10,000 miles. You can imagine why this does not get done! Add to the fact owners can not find the right information or tools and it makes neglect even worse Why not on later model years?

Kent modified this puller and developed a procedure to remove the front crank seal race so the job could be affordable from the DIY mechanic. This costs less than half the cost of the factory tool.

Do not let anyone convince you to install some super platinum, iridium or kryptonite spark plug in your old Benz. They are just not capable of handling the richer fuel mixtures associated with these older engines.

Unless the engine has been overhauled most of these old 6 cylinder gas engines of the '60s and very early '70s are running around with their original front crank seal. Take a look under your car if you have one - I bet it will look a lot like the engine in the video below.

Kent modified this puller and developed a procedure to remove the front crank seal race so the job could be affordable from the DIY mechanic. This costs less than half the cost of the factory tool.

Doing a compression test is one of the best ways to determine the internal health of your gas engine. This is a primary test for doing a physical examination.  You want to do this on any old Benz before spending a lot of money to get the engine running right or before restoring your car.

You will receive two (2) five liter bottles more than enough to do a full oil change on any vehicle:

This is the hose on the left side of your engine that seems to always rot and leak power steering fluid. If you look closely at it you will most likely see small cracks in the hose. This is the larger size hose used on those early models with power steering from the early 1960's through 1976.

Kent finally went to work to solve the problem of rusty water pump mounting bolts. Once the problem was studied carefully the solution became obvious. Watch the video for a full explanation and partial instructions below.

Kit contents:

For a number of maintenance operations, you need to be able to turn the engine over by hand. This includes valve adjustment, timing chain replacement, injection pump timing on diesel engines, checking and setting internal engine timing, draining the torque converter, and others.

PLEASE NOTE: Manual(s) are now available in PDF format and are available for viewing when you log into your account at Mercedessource. No printed manuals are shipped.  If you own a Mercedes with the M117 V8 engine timing chain failure can really ruin your day!