Search | Body and Exterior Trim

Before ordering please note which doors for which models these will fit front or rear doors on the following W126 and W124 sedans.  

Good used set of original wiper arms. Fit all 126 chassis sedans from 1981 to 1991. The wiper arm will often wear out at the base and get sloppy (that is what can make the clanking noise). These have good joints and springs. 

Good used set of left and right aluminum rear hatch alignment slide assemblies and shim plates as shown. These fit all 123 TD wagons from 1979-1985. If your rear hatch is sloppy and loose, it may be excessively worn guide plates.

Good used sunroof air dam closing guide rail, complete with good plastic tabs intact on both ends. This fits right or left side and allows the sunroof to close the air dam before it reaches the edge of the roof.

Set of four (4) new factory door striker bolts. It is very easy to round these off. If you are planning on removing or adjusting your strikers and want the original style hex bolts you should have extras on hand.

Stop those water leaks now! This high-quality rubber trunk seal fits 116 sedans (Gasoline models ONLY)from 1977 to 1980, including the 280SE, 450SE, 450SEL, and 450SEL 6.9. It now comes with complete instructions loaded with tips.

Stop those water leaks now! This high-quality rubber trunk seal fits all sedans with W126 chassis from 1981 to 1991, both gasoline and diesel. It now comes with complete instructions loaded with tips. We recommend E6000 adhesive, which can be purchased separately below.

Fits all 116 sedans 1973 to 1980. A dried out and cracked rear window seal is the number one reason for water leaks into the trunk compartment. There can be others but this should be the first on your list. Very difficult to successfully caulk an old seal.

Good used, diesel only, trunk emblem for 123 sedans, coupes and wagons. That includes: 1977-1981 300D, 1977-1983 240D and also 1977-1981 300CD. Also, 1978-1980 only 300TD wagon. The emblem was removed properly and is not bent and all three mounting pins are intact. 

Fits all Mercedes models with 14" steel wheels. Here is one brand new lugbolt. Good to have on hand as most spare tires are mounted on steel rims! Make sure to never use the lug bolts from alloy wheels on your steel wheels! The measurements are M12 x x1.5mm with a 38mm overall length.

New Hood Release Cable. Fits all 107 chassis SL convertible and SLC coupes from 1972 to 1989. 350SL, 450SL, 450SLC, 380SL and 560SL
 

Good used driver side front bumper rubber trim. Some typical slight fading but no tears in the rubber. The metal bracket is not included and fits the left front only.

Helps to delete those annoying water leaks into the trunk. Brand new quality trunk seal for your SL. Stop or prevent those trunk leaks now. Includes video instructions and recommended glue.

FITS THE FOLLOWING all 123 chassis from 1977 to 1985 which included the 230, 240D, 280E, 280CE, 300D and 300CD. (Does not fit station wagon models). Make the rear end of your 123 ride like new again.

Fits 126 Chassis sedans and coupes 380SE 380SEL 380SEC 500SEL 300SD 300SDL 350SD 350SDL 420SEL 300SE 300SEL 560SEC and 560SEL from 1981 to 1991. The best way to restore the original ride and feel of your Mercedes is to replace your shocks with new Bilstein shock absorbers.

FITS THE FOLLOWING: all 124 chassis. Are you tired of the poor windshield wiper blade on your 124 Mercedes? The chattering, streaking and squeaking never seem to end. Install this newly designed Bosch Micro Excel blades and you will not believe the difference.

If your steering is feeling a little weak or mushy replace the steering shock absorber. Easy to install on the cross steering link with only two bolts. It comes with instructions for easy installation!

FITS THE FOLLOWING: all 201 chassis (front doors only). A new set of two (2) FRONT door check straps for your 201 chassis Mercedes Benz 190E and 190D.

Fits all 113 chassis 230SL 250SL 280SL 1964 to 1971. BRAND NEW high-quality rubber trunk seal. As of 4/18/24 you will now receive Kent’s favorite trunk seal glue at no extra cost. Also, consider this. If you find any rust spots under the rubber (very common) treat with miracle paint before installing the new seal. We include E6000 adhesive which Kent feels is the very best glue you can use for this application. 

IMPORTANT NOTE ON INSTRUCTIONS: This video shows Kent installing a trunk seal in a 1970 280SL.

FITS THE FOLLOWING: all 201 chassis 1986-1993 WITH Single Wiper Blade.

Fits the following: All 123 wagons 240TD 300TD 280TE from 1979 to 1985.

Fits 115 chassis from 1974 to 1976 AND 123 chassis all models 1977 to 1985. Brand new part! This is a common item that breaks or wears out. This is the hood release lever that is located inside the car. If you are tired of using pliers to open your hood this should help.

Fits all 123 300TD wagon rear wiper assemblies. High quality Bosch Excel wiper blade that will correctly fit on the rear wiper arm. Don't settle for a cheap replacement that can scratch your rear window glass. Check out our matched 123 front wiper blade set.

FITS THE FOLLOWING: all 123 chassis sedans and wagons from 1977 to 1985.

This is a drivers side Front OR rear door striker plate. We also offer this item in a full kit with instructions, bolts and special tool. Look below to order the complete kit.