ALERT: Miracle Paint is back in stock! CLICK HERE to order.
A 12 volt test light is a very handy tool to have when working on any car but it is particularly important if you have a old diesel. This tool will allow you to quickly determine if there is power getting to your glow plugs, and if not where the power is breaking down.
Good ground cable as shown. You will need to supply your own bolt
When replacing the steering lock assembly in your Benz you will need to remove that little black plastic switch on the side of the lock from the old one and put it on the new part. You can not pry it off, squeeze it off or pull it off by hand.
Tired of lugging around heavy batteries or battery boosters to test electrical components in your car? It does not have to be a Mercedes. It does not even have to be a car. Anything that runs off 12 volt DC power can be tested by these small, light weight but very powerful batteries.
If your rear door power window is not moving or the motor is not making any noise, it could be a failed motor, rear door switch, front switch or even a wiring problem. Trying to narrow down the problem can be frustrating unless you know the proper troubleshooting sequence.
If your engine temperature gauge is not reading at all, you need to fix it before you keep driving the car. To ignore this could lead to major engine failure, since you will have no way to get an adequate warning that your engine is about to overheat.
Works on most 116, early 107, 114, 115 and early 123 models from the early 70s up to the end of the 1970s. This is a replacement for the Bosch rectangular voltage regulator (see image below) those cars that use an internal voltage regulator.
Buy a spare to carry in your trunk! FITS THE FOLLOWING: Late 107 and 116, 123, 126 up through 1991 and 201 and 124 chassis to through 1989. ALSO FITS 1990-1993 300D 2.5 AND 92-93 190E 2.6 ONLY!
W116 driver power window failure is very common. It happened to Kent's personal 1979 300SD.
Fits chassis 116 123 126 124 and 201 Diesels with pencil glow plugs, from 1978 to 1989. This includes the OM617, OM601, OM602, and OM603 engines. They also work on 1977 to 1979 300D 300CD and 300TD with series glow plugs. This pack includes three individual fuses.
Can be installed on the following models: Please read carefully. All Turbo 116 and 126 300SD 1978 to 1985. All 123 turbo and non turbo 240D 300D 300CD 300TD 1980 to 1985. 1984 to 1989 201 190D. 1986 to 1991 126 300SDL 350SD and 350SDL. 1986 to 1993 124 300D and 300TD.
An annoying problem on many older Mercedes up to 1980 that have an aluminum housing surrounding the turn signal arm latching assembly. When these wear out the lever will not hold position when you push it up or down.
To many people, automotive electrical systems and testing are a big mystery. It is not as complicated as you might think.
When an old Mercedes ( or any other car for that matter ) has sat idle for over a year it can be a challenge to get it safely back on the road again. If it has sat idle for more than 5 years you may find it difficult to even get the engine running.
The power window is stuck closed. Do the tests outlined in this video first. You may have to remove the regulator and to do that; you have to lower the window. But how???
Motor recently bench tested by Kent. The unit runs smoothly and gears are in good condition.
If you need internal parts for your failed Hirschmann antenna this is the best we have. Very clean and very strong running motor. Recently tested by Kent. Motor runs smoothly and gears are in good condition. Extra parts included as shown.
When removing valve covers or changing wires, replace these with new ones. They may look good, but they usually break due to engine heat and age.
These will no longer be printed when these are gone. They will still be available as a download. All books are signed by Kent. This is an end of an era for us. Most books are approximately 15 pages in length and covered with heavy clear plastic.
Often rotten and torn. Replace with new when working on your fuel delivery system. PLEASE NOTE: These are included when you purchase any of our fuel pump delivery kits.
In this 10 minute instructional video Kent will explain why you want to "jump" your K-jet fuel pump relay, how to do it, how to find the location in you car, and why he prefers to have a long "switchable" jumper.
This is a high-quality ACM aftermarket part. The fan runs smooth and air movement is very strong.
To many people, automotive electrical systems and testing are a big mystery. It is not as complicated as you might think.
This 17-minute video will cover the removal of an old Hirschmann power antenna and then Kent will show you how to troubleshoot the wiring plug in the car to see if you are getting proper power back to the antenna. No sense in replacing a faulty antenna until you make sure your wiring is OK!
In this xx-minute long video, Kent will show you how to install our aftermarket power antenna in your 116, 123, or 123 sedan or coupe. Removal of your old antenna is not covered in this on-demand video but it is very straightforward once you remove the inner fender well panel.
Power Hirschmann antennas are no longer available new. It is possible to remove and repair the old Hirschmanns if you are willing to dig in and spend time cleaning, adjusting, lubing, etc.
When the motor won't move the window down you can not get to the bolts that hold the regulator to the glass. So then how can you get it out of the door! What a pain! In this xxx minute video Kent will show you what you need to do in order to get a "stuck" power window regulator out of a door.
Fuses, supplies, and video instructions (below) to restore most older fuse boxes to better than original condition.
Fuses, supplies, tools and video instructions (below) to restore most older fuse boxes to better than original condition.
Excellent used over as shown.
This is a must-have if you have a prized Benz or any car you don't drive often!! If you let any of your cars sit for long periods ( generally over 30 days) without driving them, you can ruin your battery, especially if you let it go completely dead.
Good working rear door panel mount power window switch as shown.
Good used plug and wire as shown for the AC compressor. Will need to be spiced into your original wiring.
In this video instruction Kent will show you how he installs our battery tender kit in a W124 Mercedes.
After years of "fighting" fuse replacement, Kent finally decided he had had enough! And so was born another special tool. It is designed to securely grab hold of a ceramic fuse, remove it from it, and replace it with minimal exertion and no damage.
In this video Kent explains some of the key reasons for poor battery contact and loss of voltage to important electrical components. If you want your later model Mercedes to run a peak performance pay attention to your battery.
Have you been having electrical problems in your older Mercedes? Maybe you have taken the fuse box cover off and wiggled a few fuses and it has solved the problem for a while. You probably noticed corrosion on the tips of the old aluminum fuses.
Digital PDF instructions for cleaning your pencil glow plug chambers. 5 pages of step by step instructions with detailed pictures to visually assist you in completing the job.
Applies to 190D, 200D, 220D, 240D, 300D, 300CD, 300TD and 300SD (Not for 1984 to 1985 190D) Downloadable PDF eBook 3 explains how to properly remove and replace the glow plugs in the early diesel engines up to 1985.
This is a must-have if you have a prized Benz or any car you don't drive often!! If you let any of your cars sit for long periods ( generally over 30 days) without driving them, you can ruin your battery, especially if you let it go completely dead.
Good used headlight plugs. Excellent contacts but main wire has been cut and will need splicing with butt connectors.
Genuine MBZ Part with wiring plug for later models: Please note this buzzer is really for the 1985 and later models. The wiring pigtail is not used on pre-1985 steering locks. The switch itself is the same but for older models you will have to install and leave the pigtail connected.
We only have a few of these custom machined early 300SD steering locks left. LIMIT ONE per customer. We have been informed that there is no plan to manufacture new steering locks again for these classic old diesels
Includes 1 meter of nylon braided clear windshield washer hose. No instructions included.
CLICK HERE to view the complete windshield washer squirted kit.
Get a spare. These will soon be NLA. NEW OLD STOCK Genuine Mercedes Ignition Switch. Fits early 123 chassis up through 1979, early 107 450SL from 1973-1980 and 1977-1980 116 300SD, 280SE, 450SE, and 450SEL.
Application: Fits all 5 cylinder 116 and 126 Chassis diesel engines 300SD from 1978 to 1985 and all 123 Chassis 300D, 300CD and
Application: Fits all 116 and 126 Chassis 5 cylinder diesel engines 300SD from 1978 to 1985 and all 123 Chassis 300D, 300CD and 300TD from 1980 to 1985 with pencil glow plugs. Excellent quality. Five Bosch Duraterm pencil plugs with installation instructions.
Rebuilt 65 amp alternator without pulley or fan. You will need to install the fan and pulley from your existing alternator. The voltage regulator is included. No Core charge. No hassle trying to have to ship back your old one.