Recently Added Products

Displaying 1551 - 1600 of 1961
$17.95

Pentosin DOT4 Brake Fluid - One Liter

Higher Performance Fluid - direct replacement for DOT 3 - All Models

WARNING: Can only ship inside the USA via UPS GROUND. If you have other items in your cart do not choose expedited shipping or US postal service! High Performance low moisture absorbing DOT brake fluid.

$3.75

615 616 617 Diesel Valve Cover Wave Washers x 8

All 200D 220D 240D 300D 300CD 300TD 300SD 1964 to 1985

These washers are installed right under the four nuts that hold the valve cover securely to the cylinder head. They help to prevent the over tightening of the valve cover as well as prevent the nut from loosening up. They also keep the nut from gouging the metal out of the valve cover.

$3.90

126 300SD Oil Pressure Sending Unit Plate Gasket

Fits 1981 to 1985 300SD Only

This is a common oil leak area on the 300SD. The gasket fits between the oil filter housing and the plate that mounts the oil pressure sending unit. This is a genuine OE gasket.

$148.50

W126 300SD Monovalve Housing, Electric Aux Pump, Bracket and Hoses - USED

Good working condition. Fits 1981 to 1985 126 300SD and 380SE / L

Good used monovalve housing and hoses as shown. One hose is missing. Electric pump runs smoothly and these are no longer available. Good pump bracket. Mono valve switch assembly and plunger is NOT INCLUDED. SEE RELATED PRODUCTS below to order separately.

$38.00

W126 300SD Left Rear Tail Light Bulb Holder ( Used )

Also fits other 126 chassis 1981 to 1991

Very nice used driver side taillight bulb hold complete with attachment locking tabs. Can not guarantee bulbs. If you are having tail light problems with could be the problem (loose wiring and corroded sockets).

$68.50

Early W126 and Most W123 Power Sunroof Plastic Slide Assemblies ( Used )

Full set as shown. Very important to the smooth operation of your sunroof

The plastic slides can easily break off and the plastic bushings can fail in the lift arm pins. When this happens, your sunroof may bind or not slide properly or fully close. This is the actual set you will receive for the right and left side.

$39.50

W123 300D and W126 300SD Sunroof Driver Side Rear Slide Bracket Adjusting Pin ( Used )

This pin and sliding nut are often rusty and they can break off during sunroof removal. Only to 1985 non- tilting ELECTRIC sunroofs

Left rear pin and slide as shown. This is a common rust part and the threaded pin must be removed to remove the sunroof panel. This pin also rides up on a ramp to close the rear of the sunroof flush with the roof and is adjustable for the rear edge closing.

$49.00

Late W116 and Most W123 Sunroof Passenger Side Rear Slide Bracket Locking Pin ( Used )

Also fits 1981 to 1985 W126. LAST ONE! Locking pin often rusts shut - this is important for rear roof height adjustment.

Right rear pin and slide as shown. This is a common rust part and the threaded pin must be removed to remove the sunroof panel. This pin also rides up on a ramp to close the rear of the sunroof flush with the roof.

$98.00

126 Chassis New Rear Spring

Fits all 300SD 300SDL 350SDL 380SEL 500SEL 420SEL 300SE 300SEL 1981 to 1991- NOT 560SEL and 560SEC

Special order item. Please do not expect immediate shipment. Rear Spring replacement on these big 126 sedans is often necessary to fix persistent rear end sag problems - especially if car has been driven with heavy loads in past. Brand new high quality Lesjofors spring.

COIL SPRING

$105.00
Currently out of stock.

126 Sedan Driver Left Side Chrome Door Pull New

For All 126 Chassis 300SD 380SE 500SE 300SDL 420SEL 560SEL 300SE /L 350SD

Fits all 126 sedans 1981-1991. New Genuine Mercedes interior door chrome opening handle. This door pull can be installed on either the driver side front or rear door. If yours is sloppy and loose here is a good chance to replace it now.

$32.50

W123 Power Sunroof Track Felt Feet Slides

Most models 280E 240D 300D 300CD sedan and coupe power roofs 1977 to 1985 (note exceptions)

These are the Genuine Mercedes felt feet (pad or pads ) that most W123 sunroofs slide back and forth on (note - there are some early models that did not use these - inspect your feet before you order! Most wagon manual sunroofs do not use them either - check your roof first.

$11.95

Lubro Moly Motor Oil Saver - For Diesel and Gasoline engines

UPS GROUND SHIPPING ONLY!

Another High Quality product from Lubro Moly. This is a 300ml can of Motor Oil Saver. It Rejuvenates rubber and plastic engine seals and reduces oil consumption via the piston rings and valve guides; counteracts the loss in viscosity of motor oils.

$6.50

Lubro Moly CV Rear Axle Joint Grease

LM 47 for chassis 114 115 107 116 123 126 201 124 and 129

Another high quality product from Lubro Moly. This is a 90g tube of CV Joint grease for long term lubrication use. It is excellent for wheel bearings and ball joints as well.

$13.75

Lubro Moly Gear Oil Additive

MoS2 Anti-Friction Anti-Whine for Gears

Another high quality product made by Lubro Moly. This is a 50g tube of Gear oil additive. It is a concentrated moly based treatment for manual shift transmissions, differentials, steering boxes, transaxles, and rear axles. Reduces Gear noise and whine, smooths shifting.

$269.00

220D and 240D Clutch Pressure Plate and Disc by Sachs

Fits models 1968 to 1983. Best you can buy. You might want to purchase while these are still available.

In stock now. If you are going to pull your transmission to replace any clutch components you should do it right! That means to replace all key wear components so you don't have to remove the transmission again any time soon.

$79.00

Late 240D 300D Clutch Release Bearing w/ New Pilot Bearing

Fits 1980 to 1981 W123 chassis 240D with vin # 123.123 - from 219675 and up.

If you are going to pull your transmission to replace any clutch components you should do it right! That means to replace all key wear components so you don't have to remove the transmission again any time soon. Go with the best so the repair will last the longest.

Sale
$75.00

Mercedes 123 240D 300D 300CD and 116 300SD Original U.S. First Aid Kit (Used)

All white will original internals

This is an original first aid kit. It came out of a 1981 300D.  Contents look mostly complete and are original. I have 2 so it may or may not exactly have everythings inside as shown below.  It probably should not be used as a first aid kit. This should be for original cosmetic purposes only.

$35.00

Late 616 and 617 Diesel Engine Vacuum Pump Cover Plate (USED)

Fits 1981 to 1984 240D 300D 300TD 300CD 300SD

Make certain your pump only has one main line coming into it. Very good cover plate as shown. No cracks or wear. No other parts included. To be used if your cover plate gets damaged. Sorry no complete used pumps available.

USED

$15.95

Front Crank and Transmission Seal Removal Tool

Helps to remove 616 and 617 Diesel Engine Front Crank Seals and automatic transmissions from 1965 to 1995

If you have a leaking transmission seal it can be a real bear to get the old seals out without this puller tool. It works on both the front and rear transmission shaft seals. This tool also works great for removing the front crank seal on both gas and diesel engines.

$3.80

617 Turbo Transmission Oil Cooler Line Banjo Washers (Set of 4)

Fit 123 and 123 chassis turbo diesel transmissions 1981 to 1985 Also will work on the banjo bolt for the turbo charger oil feed line.

Common diesel transmission leak source. These aluminum washers fit on each side of the banjo connection where the oil cooler lines bolt to the right and left front side of the transmission case. Fit 300D 300TD 300CD and 300SD with automatic transmissions from 1981 to 1985.

$72.15
Currently out of stock.

115 116 107 123 126 Chassis Rear End Wheel Bearing Kit

Inner and Outer Bearing and Seals for ONE SIDE ONLY (Right or Left)

This complete kit ncludes both inner and outer rear end wheel bearings and seals with groove nut and grease. Fits chassis listing above including the 123 300TD wagon, from 1974 to 1991. If you need bearings for both sides order 2 of these kits.

$12.75

123 300TD Wagon Rear Suspension Coil Spring Shim - Maximum

Used to adjust unloaded ride height

This is a maximum thickness rubber shim (19 mm thick) to adjust the ride height when installing new or reinstalling existing rear coil springs. Two required per car. Also fits 114, 115, 116, 123 sedans and coupes and 126 chassis cars.

$9.95

116 123 126 Rear Suspension Coil Spring Shim - 14 mm

Fits All 240D 300D 300SD 300TD from 1977 to 1985

This is a medium thickness rubber shim (14 mm thick) to adjust the ride height when installing new or reinstalling existing rear coil springs. Two required per car. Fits 116, 123 sedans, wagons and coupes and 126 chassis cars.

$299.50

123 300TD Wagon Rear Suspension Coil Springs (PAIR OF 2)

MINIMAL INVENTORY!!!! Fits all W123 300TD Chassis wagons from 1979 to 1985 -- Factory Height 13.5 inches

These special springs are unique to wagons only. They are designed to only support the weight of the car when it is unloaded. With age and malfunction hydraulic struts these springs can weaken and allow the rear of the vehicle to sag.

$208.50
Currently out of stock.

W123 Wagon, W201 16V, and W126 560SEC Rear Suspension Accumulator Spheres x (2)

Very limited stock. Most common failure item on self-leveling suspension (SLS). Get a spare par. May soon be NLA.

There are two gas filled accumulators of this style under the rear of the 1979 to 1991 123 300TD wagons, 201 190E 16v and 126 560SEL sedan and 560SEC coupes with self leveling rear suspension ( SLS ).

$79.50

W107 W126 Chassis 380 V8 Engine Thermostat and Short Hose Replacement Kit

For 380SL, 380SLC, 380SE, 380SEL and 380SEC. When replacing an old thermostat always replace the short hose that it is attached to!

Brand new thermostat, heavy-duty short hose, and 2 new clamps. Fits all 126 Chassis 380 engines from 1981 to 1985 both in 107 chassis and 126 Chassis. Free Video installation tips included ( click on the arrow in the center of the picture to watch below:

$15.95

Power Steering Fluid - Per Liter

All Models with power steering from 1958 to 1985

This item can only be shipped UPS Ground because it is a liquid. One Liter of correct Power steering fluid. Fully compatible with Dexron II systems but has enhanced aditives to reduce steering box gear wear.

$46.75

103 Engine Bosch Distributor Rotor

All 6 Cylinder Gasoline Models from 1986 to 1992

Fits 124, 126 and 201 chassis - 124 Chassis 300E 2.6, 260E, 300E, 1986-1992, 1988-1989 300CE,  126 Chassis 300SE, 300SEL, 1988-1991, 201 Chassis 190E 2.6, 1987-1993.

Brand new Bosch Distributor rotor for above models.

$29.75

Late W123 Wagon SLS Rear Single Strut Top Rubber Mounts - USED

Some W123 300TD - THERE ARE TWO STYLES!!! note picture to make sure the style matches what you need
These are the Top rubber pieces that mount to top of the rear hydraulic struts to the body of SOME 123 wagon. FOR ONE STRUT ONLY on left or right side. Will only work on wagons that have the curved rubber mount as shown in the picture. These parts are in very good condition.
$26.50

102 103 104 and V8 Gas Engine Fuel Pump Check Valve

Fits most gas models from mid to late 1980s up through mid 1990s (exceptions noted)

Each fuel pump has a critical check valve mounted at the pump outlet. The purpose of this check valve is to prevent fuel from leaking back through the pump after the engine has been shut down. Constant fuel pressure must be held in the fuel system for the engine to restart quickly.

$126.00

W123 Front Suspension Guide Rod Mount Kit - for Both Sides

Fits all 240D 300D 280E 280CE 300CD 300TD 1977 to 1985

When these part wears, the control rod will move back and forwar and the joints will clunk when you go over bumps. This is becoming a very common failure part on these older 123 chassis. We provide you with replacements for BOTH sides (inner and outer as shown).

$28.50

123 126 Front Suspension Guide Rod Mount Kit x 2

Fits all applicable W123 and W126 1977 to 1991 sedans, wagons, and coupes - Right and left sides included

Bushing kit that attaches the front suspension guide rod to the lower control arm. This is a wear point that is often neglected and if loose can cause clunking in the front end. This is a complete kit for both sides. 2 kits included.

$9.75

All 116 123 126 Front Upper Control Arm Bushings x 2

For W116 W123 and W126 chassis models from 1973 to 1991 - ( NOT for R107, W201 or W124 chassis)

These bushing go on either side of the upper control arm where it attaches to the stabilizer arm. These should be replaced if worn or installed new upper control arms. SOLD IN A SET OF 4 as required by car. See related products below for the upper control arms that these bushing fit into. 

Most Models 1965 to 1991 Front Brake Disc Mounting Bolt
$4.75

Most Models 1965 to 1991 Front Brake Disc Mounting Bolt

Fits 111 113 108 107 114 115 116 123 126 Chassis

When replacing front brake discs on above chassis it is highly recommend you replace the bolts that hold the rotor to the bearing hub. Not needed on 201 124 or 129 chassis. Sold individually. 5 required per wheel.

Pages