Search | W108 W109

We have been looking for a long time to find a super strong and well made tool to adjust those tough 17 mm ball adjuster sockets on the early 4 and 6 clyinder gas engines.

This U.S.A. made 17 mm 8 inch long combination wrench is custom modified here in our shop to help you easily install Bilstein front and rear shocks on most of the older model Mercedes Benz.

Brakes are one of the most often neglected maintenance items on older cars. This is not just related to Mercedes Benz. Most owners don’t realize that brakes need special attention and service not only when pads are changed but every 2 years.

These are all 3/8 inch drive hex sockets. All are the same length 11 cm total length. These are great to have with the short hex just won't reach long enough. 

When Kent set out to find a good fender cover for his own use he and Kaia decided to make it available to our customers. Who doesn't like a good soft fender cover that stays in place? We know red shows the grease more than black but you have to admit these are a knockout!

Dirko sealing compound is permanently elastic, cold vulcanizing, silicone-rubber based. Can be used for connecting joints, cylinder head, crankcase, oil sump, timing case, thermostat, water pump, transmission, axles, differential, radiator, chassis.

Sil-Glyde is a silicone based brake lubricant recommended for the entire brake assembly and is compatible with rubber. It is moisture-proof and heat resistant to +600 degrees F, which means it won't burn-off like other brake noise products.

This is a must-have if you have a prized Benz or any car you don't drive often!! If you let any of your cars sit for long periods ( generally over 30 days) without driving them, you can ruin your battery, especially if you let it go completely dead.

Nice set of pick tools with plastic handles. They have strong steel tips which allow for more prying and twisting with less tendency to bend the tips as you would with dental pick tools. Note: Quarter is not included! Shown for size reference only

Replace those nuts that keep loosening up with nylock metric nuts that just won't come off. Inside the door panel on the window regulators. Around the engine compartment. Air filter housing nuts. etc. etc.

I have used a lot of different clamping tools over the years to prevent fluids from leaking out when removing coolant, fuel, or brake fluid hoses. Most work ok. Some are hard to use in tight places.  Many do not stop every last drip from coming out of the hose.

This set of 5 pick tools have very thin and sharp points. Best set Kent has found to remove orings in hard to get to locations. The variety of angles available allows you to get into almost anywhere to remove and o-ring, sealing ring or other small part.

This is the absolute best gasket maker when you have a clean and tight metal to metal contact. Examples of where you would use this is SEALING the rear differential cover, aluminum oil pan where is mounts to the engine block, etc.

This is one of Kent's favorite tools. Lets you reach into tight places - very long nose curved pliers with teeth - like hemostat. With the locking handles it is amazing what this clamp / pliers can hold - and the tight places it can get into!